Life Member
  • Content Count

  • Joined

  • Last visited

  • Days Won


428 last won the day on August 16 2019

428 had the most liked content!

Community Reputation

133 Excellent

About 428

  • Rank
    retired moderator

Contact Methods

  • Website URL
  • ICQ

Profile Information

  • First Name
  • Car
    ADM VIII G Spec
  • Location
    Canberra region
  • Gender
    Not Telling

Previous Fields

  • Interests
    Lurking, and enigmacity

Recent Profile Visitors

2,635 profile views
  1. Ivan any chance you can do a sub-version that is just the master cylinder brake stopper, no bar?
  2. Nice gear Ivan - really appreciated the new wipers with the heavy rain over last few days, just in time....
  3. Quickiest buy I have on the forum ... the rotors are better condition in real life then in picture. :)

  4. thread tidied - facts sell themselves
  5. John - forum policy:, all used rotors for sale must have accurate thicknessess published in the for sale thread please measure them up ASAP if you wish to have them listed for sale.
  6. Just installed mine today - feels much lower that I had expected. Plus is you can really feel what the car is doing, down side is you now need to imagine where the bonnnet ends. Harness - my inner eyelet is fitted to the tunnel wall not the seat - clears just fine. Seat slide adjustment handle - it still locks just fine, I didn't need to bend it. Installation - take the seats out and loosely fit the brackets, tighten the bolts only once the seat is back in the car and you are sure you have it right. Nice mod - thanks Resart
  7. I had the same problem as Pete fitting my front whiteline sway (didn't know he had been though it) - a mishaped bar couldn't be fitted, to WL's credit they got another to me the next day but the car was taking up a (busy) mechanic's hoist for an extra day. The rear sway fitted first go but I found a few months later was fouling a drive shaft and also had to be replaced. Regardless, I've never heard anyone question Mark's product quality or ethic of service, nor has anyone said JDM/ADM or USDM products are categorically better in all things - that discussion is a distraction from this thread's purpose: Discussing an Australian-developed 20G for evos - one that an awful lot of people rate highly for street and track applications On that note - Mark, if you'd like the thread cleaned up (refocussed) we can split the less relevant discussion off into another area.
  8. Folks please avoid unecessary moralistic or opinionated comment on this matter - as it is being addressed appropriately by the vendor. It is clear that Ivan is working hard to keep his customers informed and to meet his professional obligations by doing everything that could be resonably be expected of him as a Vendor to rectify the situation. It is an excellent outcome that the problem with this product has been identified however note that Ivan has dealt in good faith and has apparently been let down by his supplier, as much as everyone else. If the issue is not resolved satisfactorily then by all means post as a customer - but after you have discussed any concerns with the vendor, pm would be a suitable medium. The mod team will continue keep an eye on developments to ensure the interests of both the members and the vendor are met.
  9. 4 months without prices - is unacceptable, topic locked
  10. Idle curiosity here - are these cast, spun or (less likely) forged?
  11. Cheers Mark, I'm across the application for higher boost, but is the improvement torque, power.... something else?